Break-Even Occupancy

Break-even occupancy is the occupancy level at which a property’s income just covers its operating expenses and debt service, leaving no cash flow, and it shows how far occupancy can fall before the property stops paying its own loan.

Formula

What is the break-even occupancy formula?

Break-even occupancy = (operating expenses + annual debt service) / potential gross income

Variant with other income held fixed = (operating expenses + annual debt service - other income) / gross potential rent

  • Operating expenses: the underwritten expenses, here before replacement reserves; many lenders include reserves in operating expenses, which raises the result.
  • Annual debt service: twelve months of principal and interest.
  • Potential gross income: gross potential rent plus other income, at full occupancy.
  • Gross potential rent: every unit at its scheduled rent.

The formula assumes all expenses are fixed. In practice some, such as utilities, turnover and management fees, fall as occupancy falls, so the true break-even is somewhat lower than the formula shows. Lenders usually accept the simpler figure as the more conservative one.

What is break-even occupancy on the sample deal?

Illustrative figures for the 96-unit community refinanced with a $9.0 million loan.

  • Operating expenses: $584,000
  • Annual debt service: $665,000
  • Potential gross income: $1,486,000 + $58,000 = $1,544,000

Break-even occupancy = ($584,000 + $665,000) / $1,544,000 = $1,249,000 / $1,544,000 = 80.9 percent.

Occupancy today is 94.8 percent, so the cushion is 13.9 points. Adding the $24,000 replacement reserve gives $1,273,000 / $1,544,000 = 82.4 percent. Under the variant: ($584,000 + $665,000 - $58,000) / $1,486,000 = $1,191,000 / $1,486,000 = 80.1 percent.

With the rate one point higher, debt service rises to $736,750: ($584,000 + $736,750) / $1,544,000 = $1,320,750 / $1,544,000 = 85.5 percent, and the cushion narrows to 9.3 points. The same stress takes coverage from 1.31x to 1.18x.

How do lenders use break-even occupancy?

Break-even occupancy translates DSCR into a figure a lender can compare with the market. A property that breaks even at 80.9 percent in a submarket where occupancy has stayed well above that through past cycles has real room. The same break-even in a submarket that has dipped below it, or on a property with one large tenant, leaves far less room.

Typical policy treatment (illustrative): the sample lender shows break-even occupancy with and without the replacement reserve and at the stressed rate, beside DSCR, and compares it with submarket occupancy. It sets no separate limit.

What are common break-even errors?

  • Leaving out replacement reserves or required escrows that the property must also fund, which understates break-even.
  • Using interest-only debt service when the loan amortizes, or the reverse.
  • Comparing break-even with physical occupancy when concessions and bad debt mean economic occupancy is lower. On the sample deal, trailing vacancy and credit loss was 6.0 percent while physical vacancy was 5.2 percent.
  • Applying the formula to a single-tenant building, where occupancy is either full or empty.

Where does break-even occupancy appear in the credit memo?

It sits in the cash flow analysis or the sensitivity section, next to DSCR, debt yield and the stressed figures, and the market section compares it with submarket occupancy over time.

Related terms

Vacancy and credit loss, DSCR, stress testing, operating expense ratio, loan sizing.

Where LenderBox does this work

With loan sizing and deal structuring, LenderBox sizes the loan at today's rate and under stress on rate and income, with the stressed results beside the base case, so your team can judge the cushion before quoting.

See it worked on a deal you bring.

A 30-minute demo can run on documents you bring: LenderBox reads the file, shows the source page behind each figure, and checks the result against your credit policy.

See it on your deal
30 MINUTES. NO COMMITMENT. 90-DAY MONEY-BACK GUARANTEE.