Replacement Reserves
Replacement reserves are an annual allowance, usually stated per unit or per square foot, for replacing a property’s long-lived components such as roofs, mechanical systems, parking surfaces and unit appliances, either underwritten as a deduction from income or collected monthly into a lender-held account.
What is the replacement reserve formula?
Underwritten replacement reserve = reserve per unit (or per square foot) x units (or square feet)
Monthly reserve deposit, where required = annual reserve / 12
- Reserve per unit or per square foot: the higher of the lender's policy minimum and the property condition report's forecast of capital needs over the loan term.
- Units or square feet: the property's total, occupied or not.
- Annual reserve: the underwritten reserve for the year.
Underwriting a reserve and collecting one are separate decisions: a lender can deduct a reserve in underwriting without collecting cash, or require monthly deposits that are released to reimburse completed capital work. This glossary deducts the reserve below NOI to reach net cash flow; many lenders include it in operating expenses instead.
What are replacement reserves on the sample deal?
Illustrative figures for the 96-unit community refinanced with a $9.0 million loan.
- Underwritten reserve: 96 units x $250 = $24,000 a year
- If collected monthly: $24,000 / 12 = $2,000 a month
- Net operating income of $871,000 less the reserve: net cash flow of $847,000
- Coverage: 1.31x on NOI, 1.27x on net cash flow, against $665,000 of debt service
The T-12 has no reserve in its $584,000 of operating expenses, so the lender adds it below the line. With the reserve, break-even occupancy rises from 80.9 percent to 82.4 percent. The units were renovated before the refinance, at $11,000 each, which lowers near-term interior spending but does not stop roofs, boilers and paving from aging.
How do lenders use replacement reserves?
A property that spends nothing on capital for several years shows higher NOI and then needs a large outlay at once, often near maturity when the lender needs the property to refinance. Underwriting a reserve spreads that cost over the years it accrues, so coverage is measured on cash the property can actually spare. Collecting the reserve in cash protects the lender if the borrower would otherwise distribute it.
Typical policy treatment (illustrative): the sample lender underwrites at least $250 a unit on apartments, or the property condition report's figure if higher, and collects monthly deposits on non-recourse loans and older properties. The recourse sample refinance underwrites the reserve without collecting it.
What are common replacement reserve mistakes?
- Accepting a borrower's pro forma with no reserve at all.
- Counting the reserve in operating expenses and again below NOI.
- Using a policy minimum when the property condition report forecasts more.
- Releasing reserve funds for routine repairs that belong in operating expenses.
Where do reserves appear in the credit memo?
The underwritten cash flow shows the reserve line and its basis (policy, property condition report, or both). The loan terms state whether deposits are required, the monthly amount and release conditions, and the collateral section summarizes the property condition report's capital forecast.
Related terms
Net cash flow, net operating income, operating expense ratio, break-even occupancy, DSCR.
Where LenderBox does this work
With credit box and policy, LenderBox holds each limit in your credit box by property type, with the section of policy it comes from, so a reserve below your minimum is flagged with the reason before committee.